Some of my screenshots of this session, a session that started a bit with a problem for me also.... first a right engine shutdown shortly after takeoff... followed closely by a windscreen freezing up ....
Luckily we managed to get things going again.
Leaving Sparrevohn with Dave just visible in the right lower corner
Setting up for TG at Kenai (PACN) RW01
and taking off again, notice Christian at the left
Enroute to Anchorage Intl
...Christian ahead
...Dave behind
Setting up for TG at Anchorage RW07R
And taking off again, notice Dave
Christian about to perform his TG at Willow
Next TG at Palmer Municipal (PAAQ) RW09, notice Dave ahead
... and Christian performing an interesting manouvre
Leaving Palmer we had to climb to 15.000ft to clear the mountains enroute to Valdez (PAVD)
.... circling over Valdez
... cruising at 9.000ft; passing a glacier while enroute to the final destination of todays MPSession, McCarthy (15Z)
Arrived at McCarthy...
....Christian (in a pale white aircraft... apparently the textures of this AI aircraft are not compatible with DX10... will return to good old DX9 next week :-) )
.... and Dave
It was nice to have been able to join the MP session again.
See you back next week !
Luckily we managed to get things going again.
Leaving Sparrevohn with Dave just visible in the right lower corner
Setting up for TG at Kenai (PACN) RW01
and taking off again, notice Christian at the left
Enroute to Anchorage Intl
...Christian ahead
...Dave behind
Setting up for TG at Anchorage RW07R
And taking off again, notice Dave
Christian about to perform his TG at Willow
Next TG at Palmer Municipal (PAAQ) RW09, notice Dave ahead
... and Christian performing an interesting manouvre
Leaving Palmer we had to climb to 15.000ft to clear the mountains enroute to Valdez (PAVD)
.... circling over Valdez
... cruising at 9.000ft; passing a glacier while enroute to the final destination of todays MPSession, McCarthy (15Z)
Arrived at McCarthy...
....Christian (in a pale white aircraft... apparently the textures of this AI aircraft are not compatible with DX10... will return to good old DX9 next week :-) )
.... and Dave
It was nice to have been able to join the MP session again.
See you back next week !
STefaan Cappelle
TCA2050
TCA2050